Το προϊόν δεν
είναι πλέον διαθέσιμο |
| Τιμές χωρίς ΦΠΑ |
|
|
ESP8266 Test Board
The board comes with a ready soldered ESP8266 ESP-12E 32Mbit soldered to it.
PINS
All the pins are available to the left and right of the board.
The TX, RX and GND pins are located at the top of the board. The orange jumper is for flashing the firmware when positioned or to run the firmware when removed.
LEDs
6 red leds are fixed with the necessary resistors connected to GPIO16, GPIO14, GPIO5, GPIO4, GPIO0 and GPIO2.
A blue LED is always on when the board is powered.
GPIO13, GPIO12 and GPIO15 are connected to a RGB LED which allows you color mixing using PWM.
ADC
The analog-digital converter is connected to a light resistor for testing the ADC
Battery Pack
The test board comes with a batterie pack attached which takes 3 AA cells
|
